New Car Modification Accessories Face lift Body Kit Front Rear Bumper For Toyota Alphard 2018-2014 Year

Product description

1.Surrounding is basically divided into two categories: pump handle and lip type. Among them, the surround of pump handle is to remove the original front and rear bars, and then install another pump handle. The lip type surround is to add half of the lower lip on the original bumper. The quality and installation technology of this type of surround are extremely high.

2. How to choose a suitable body for your car: (1) Engine cover: light weight, good strength, and can withstand high temperature. It is best to take the heat away from the engine. (2) Head lip: The head lip is the Aero Parts that can highlight the personality of the appearance, and the number of car owners who install it is also the most! (3) Front pump handle spoiler: The popular CANARD can be regarded as the most effective AERO PARTS for more DOWN FORCE on the front of the car, and the number of installers is increasing day by day. (4) For GT-WING, the gap between the main wing and the car body should be less than 2CM. If it exceeds this figure, 16.5CM (each side) should be reserved for the length of both ends of the main wing and the sand board of the door. (5) Skirt: The minimum distance between the height of the car and the ground after installing the surround should not be less than 9CM (about the height of a pack of cigarettes). The distance between the catalytic heat shield and the ground should not be less than 5cm. So everyone should pay more attention!

Precautions
First, high-quality products should be selected. The large surround is installed on the car, and it becomes a whole with the car. Daily bumps are inevitable. If the surround material is fragile and too rigid, it is easy to break, which will not only increase the replacement cost, but also add a lot of trouble .
Second, it is best not to choose a large enclosure that needs to be removed from the original car bumper to install, because the material used for the enclosure has poor impact resistance, so choosing a large enclosure that wraps the original bumper in it will not affect the firmness of the vehicle. However, if it is necessary to choose to remove the bar to surround, the buffer zone in the original bar can be transplanted into the glass fiber reinforced plastic surround to play a protective role;
Third, you should go to an experienced refit shop to install a large enclosure, because these refit shops have the ability to make various enclosures, and most of them will repair accidentally damaged enclosures for car owners free of charge, so that car owners do not have to worry about a small damage to the enclosure. Had to pay for a new one.